Advanced search
 Acura

 BMW / Mini

 Dodge

 Eagle

 Ford

 Honda

 Mazda

 Mitsubishi

 Nissan / Infiniti

 Scion

 Subaru

 Toyota / Lexus

 Volkswagen

 Turbo Accessories

 Coilover Upgrades & Accessories

 Interior Accessories

 Featured Items
Megan Racing Coilover Damper Kit - Track Series, Mitsubishi Evo 8 & 9 Free Shipping!!!!
$900.00
More Info...
Injen Cold Air Intake, Scion tC 05-06, FREE SHIPPING!!!!!!!
$266.00
More Info...
Megan Racing Coilover Damper Kit Subaru Impreza WRX and WRX STi 02-06 & 04 STi FREE SHIPPING!!!!
$900.00
More Info...
Megan Racing Exhaust Scion tC 04,05 FREE SHIPPING!!!!
$362.00
More Info...
Apexi Induction Box Mitsubishi EVO 8, 03-05
$167.00
More Info...
Megan Racing Cat-Back Exhaust Mitsubishi Evo IX 05+ Free Shipping!!!!!
$446.00
More Info...

Mailing List
Subscribe | Unsubscribe

Cart/Checkout
Home
Products
Your Account
Resources
Contact Us

Installation Instructions

  1. Remove cover of stock air box assembly
  2. Remove the three bolts holding the air box in place
  3. Loosen the clamp holding the OEM tube to the air box
  4. Disconnect the feed tube from the bottom of the air box
  5. Remove air box assembly from engine compartment
  6. Disconnect feed tube from front bracket and remove from engine compartment
  7. Install large rubber bushing on back mounting bolt
  8. Install small rubber bushings on remaining mounting brackets using a small piece of tape folded in a loop to hold the bushings in place while you thread the mounting bolts. (Remove the tape once the bolts are threaded)
  9. Place heat shield over mounting brackets. Use one washer on each bolt and thread the mounting bolts.
  10. Place a jack under the driver side front and lift almost off the ground. This will allow you to thread the bottom bolt by reaching inside the fender well.
  11. Tighten the bolts snug but not to tight. (8-9lbs-ft) You will damage the bushings if you over tighten the bolts.
  12. Insert the tube assembly into the stock OEM tube. Stop before contacting the air temp sensor that sticks inside the stock tube.
  13. Rotate the assembly to line up the mounting strap with the bracket.
  14. Be sure to hold the assembly-mounting strap so there is about 1/8 inch clearance between the strap and the heat shield.
  15. Check clearance of small vacuum hose to throttle cable bracket. (Poor clearance could result in hose damage).
  16. When all clearances have been checked and are good. Thread bolt with washer into bracket and tighten snug but not to tight. (8-9lbs-ft) Then tighten the clamp on the discharge tube.
  17. Place filter over end of pipe assembly and tighten clamp.
  18. Lower the car and remove the jack.
  19. GO PLAY WITH YOUR NEW FOUND PONIES!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
  Home | Products | Your Account | Resources | Contact Us
  Copyright© 2009 Bishop Motor Sports, LLC Terms and Use | Site Map